Troubleshooting Guide

 

 

Adding solutions - L2n

FAQs

0. FAQs:

 

  1. Cabinets

  2. Covers

  3. Dealers

  4. Help

  5. Insulation

  6. Jets

  7. Ozonators

  8. Pre-installation

  9. Set-up

  10. Shells

  11. Terminology

  12. Water quality

    1. Testing the water

    2. Adding tablets

    3. Draining my spa

    4. Refilling procedure

    5. Odors

    6. Suds buildup

    7. Calcium levels

    8. Scum lines

    9. Cloudy water

    10. Black spots

    11. Gelled water

  14. Winterizing

  15. Wiring

 

Adding AquaClara™ Natural Water Management System consists of three products that you periodically add to your spa: ClaraPure™ Sustain, AquaClara™ tablets, and AquaClara Enzyme.  Adding these three products is a very simple task.

 

Note: Before adding any chemicals to your spa, make sure that the water has first reached its desired temperature.

 

If this is the first time you are using your spa, do both the weekly and monthly tasks.

 

Weekly:

 

  1. Remove the cover over the filtration canister

  2. Remove the filter from the spa and either clean it with a spray of water from a garden hose or replace it

  3. Install a clean filter

  4. If required, drop in 1-2 AquaClara tablets into the filtration canister compartment

  5. Replace the filtration canister cover

 

Monthly:

 

  1. Turn the pump on HIGH on the topside control panel to vigorously circulate the water

  2. Pour one 8-ounce bottle of ClaraPure Sustain into the middle of the spa water

  3. Remove the cover over the filtration canister

  4. Pour 2 capfuls of AquaClara Enzyme into the filtration canister compartment

  5. Replace the filtration canister cover

  6. Allow the pump to run for about 30 minutes

 

After heavy bather use:

 

Add one packet of ClaraBoost™ to the spa water after heavy spa usage.

 

Next

We hope that you have found this guide useful. If you have suggestions on how to make this particular web page better, please email us at tsguide@myspaservices.com.

 

Author: Philip Rastocny