|
Adding AquaClara™ Water Management System tablets and discs to your spa is a relatively simple task.
Note: Before adding any chemicals to your spa, make sure that the water has first reached its desired temperature.
Weekly:
-
Turn off all pumps
-
Remove the cover over the filtration canister
-
Twist the filter ring to unlock the ring
-
Lift the ring and basket out of the spa
-
Reach back into the filtration canister and remove the filter from the spa
-
Either the existing filter with a spray of water from a garden hose or replace it with a new filter
-
Install a clean filter back into the filtration canister
-
Separate the basket from the bottom of the ring
-
Remove the old disc sponge from the basket
-
If required, drop in 2-3 tablets and a new sponge into the basket
-
Put the basket back onto the ring
-
Put the ring back into the filtration canister and twist it clockwise until it stops
-
Replace the filtration canister cover
-
Turn on those pumps you desire
After heavy bather use:
-
Remove the AquaClara disk from the filter basket as described above
-
Add one packet of ClaraBoost™ to the spa water
-
Turn on the pump and circulate the water for at least 4 hours
-
Turn off the pump and reinstall the AquaClara disk into the filter basket
Note: When using the AquaClara water management system the filtration cycle should be set to "02"
Next
We hope that you have found this guide useful. If you have suggestions on how to make this particular web page better, please email us at tsguide@myspaservices.com.
|