Troubleshooting Guide

 

 

Filling the spa - I2

FAQs

0. FAQs:

 

  1. Cabinets

  2. Covers

  3. Dealers

  4. Help

  5. Insulation

  6. Jets

  7. Ozonators

  8. Pre-installation

  9. Set-up

    1. Before adding water

    2. Filling the spa

    3. Testing the electrical system

    4. Programming

    5. Closing up the spa

  11. Shells

  12. Terminology

  13. Water quality

  14. Winterizing

  15. Wiring

 

Now it's time to fill your spa with water.Do not turn on the electricity yet until the spa is completely filled. Do this by:

 

  1. Make sure that the filters (in the filtration canister) are gently screwed into place. Turn them clockwise to tighten until they stop and then 1/16 turn after that being careful not to over-tighten them

  2. Connect a standard garden hose to a faucet with regular cold tap water (not softened water or hot water)

  3. Put the Aqua Clara pre-filter on the other end of the hose, put the pre-filter into the skimmer basket, and turn on the hose

  4. Fill the spa until the water level is about 1" above all jets or 1/4 inch below the top of the Weir door

  5. Turn off the hose and check again for any small leaks

 

Now that your spa is checked for leaks, continue to the next step by clicking the link below:

 

Next

 

We hope that you have found this guide useful. If you have suggestions on how to make this particular web page better, please email us at tsguide@myspaservices.com.

 

Author: Philip Rastocny